REAR-END WORK...

[BLACKHORSE]

IVE JUST CLEANED IT UP, REPLACED THE AXLE BEARINGS, PINION SEAL, PUMPKIN GASKET AND A LITTLE PAINT...


http://i275.photobucket.com/albums/jj307/BLACKHORSE_22/th_Picture027.jpg (http://i275.photobucket.com/albums/jj307/BLACKHORSE_22/Picture027.jpg)
http://i275.photobucket.com/albums/jj307/BLACKHORSE_22/th_Picture026.jpg (http://i275.photobucket.com/albums/jj307/BLACKHORSE_22/Picture026.jpg)

MARK

:cool:

[Blackie]

That came out sweet, keep up the good work

[Sweden]

Hi Mark.

That is looking good.:tu

I like your support to the axle.:D

[12pack]

Looks Good! I'm guessing your going for the original look.

[chevman57]

The rest of the car is going to have to look good now. It came out looking nice. I noticed the support also. LOL
Terry

[BLACKHORSE]

Looks Good! I'm guessing your going for the original look.


THANKS GUYS...AS FAR AS ORIGINAL LOOK...KINDA YES AND NO IF THAT MAKES SENSE LOL...I LIKED THE CONTRAST OF THE 2 COLORS, AND BOUGHT A CAN OF KRYLON RUST TOUGH ENAMEL SPRAY PAINT "PRIMER" CAUSE IT LOOKED CLOSE TO WHAT IT WAS, AND IT AS YOU CAN SEE, MATCHED DAMN NEAR PERFECTLY :tu (JUST LUCKY) THEN I SHOT IT WITH CLEAR, TO GET THE SHEEN...I'M QUITE PROUD IF YA CAN'T TELL LOL...

MARK

:cool:

[ETriggs]

Mark, I am getting ready to do the same thing. What did you use to adjust the bearing retainers? Do I need to make a tool?

[Ronny's 55]

Mark that looks good. The factory did a lot of things that looked clean.

[mickeywestsr]

My thinking is....if ya can get to it....Clean it!!!!! Thats one reason I'm so slow I guess.........

[dseale4888]

Looks good cleaned up.
Dave