BatterdBull
10-08-2006, 10:05 AM
Hello Folks,
This past week concluded several major steps. The body is now straight. All sheetmetal installation is now finished (time consuming process). Where I could I included the before shot with the after shot.
The Flaming River column is in, connected, and works!
We installed a mock-up engine to try out various headers for fit and clearance. Hedman headers work just fine. The headers in the pic are for testing only.
Something to note...never leave the camera lens uncovered while working!
When it comes to these types of posts (updates) I am not sure where to put the post. They are not question just updates. Thought I would post it in this forum. If there is a better forum for this, let me know.
DonC.
Houston
This past week concluded several major steps. The body is now straight. All sheetmetal installation is now finished (time consuming process). Where I could I included the before shot with the after shot.
The Flaming River column is in, connected, and works!
We installed a mock-up engine to try out various headers for fit and clearance. Hedman headers work just fine. The headers in the pic are for testing only.
Something to note...never leave the camera lens uncovered while working!
When it comes to these types of posts (updates) I am not sure where to put the post. They are not question just updates. Thought I would post it in this forum. If there is a better forum for this, let me know.
DonC.
Houston