Welcome To TriFive
Chevy TriFive Forums
55-56-57 Chevy Forum
Hi Performance & Racing
Fabrication & Repair Questions
Non TriFive Vehicles Special Category
Marketplace
Member for at least 30 days with a minimum of 15 posts required to participate.
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Latest Posts
-
Hi everyone. I'm watching the Nascar race taking place at the Bristol Motor Speedway. I like watching Nascar on occassion. Not a hardcore fan, but I enjoy it. One of the things that impresses me most, are their car engines. They run these engines almost constantly at very high rpm's and they...30 replies 421 views
-
We have an aftermarket wiper switch which is a bit harder to turn when activating the wipers. We used a factory reproduction but the ones we find all have a nylon back and a set screw that will eventually the whole hole will strip out. Does anyone make a knob that looks factory but is completely...6 replies 158 views
-
I'm trying to order a hood Vee emblem for 1957 belair. Supplier sell Danchuck 1956 emblem and says it also fits 1957. I've looked at pictures and they seem different. Anybody know? It's onto going on the car but to dress up the upholstered trunk compartment.2 replies 45 views
-
In early 1960's three new engines were introduced. The MOPAR slant six, The Ford 6 Cylinder (Falcon). The GM 4 cylinder (Chevy II) Which engine was the longest continually produced engine?4 replies 156 views
-
Here's where I'm at on the '57 project. The car is at a hot rod shop in Louisville, KY and I am doing the mechanical rebuilding on engine, trans, etc. I will get the rolling frame back next week and start the rebuild on it while the car is on the rotisserie at the shop. I have the engine...88 replies 10K views