I want to install power windows in my 57 2 dr.h/t I'm looking for suggestions on who has the best kits.I plan on using Woody's custom door hindges for routing the wires. I want to get this done before I redo the interior in October.
any suggestions would be apprecited.
If you're keeping the door cardboards and don't want to deal with a hole where the crank was, and you want a stock look you might consider using window crank switches. Mulitple splined shafts available to assure proper fitment. https://www.summitracing.com/parts/a...hoCAoYQAvD_BwE
When in danger, when in doubt.
Run in circles, scream and shout.
"TIP... Once the old rear regulators are removed take a dremel and lengthen the slotted adjustment holes about 1/4"".
1/4" at each end of the holes?
Also, how much of the original parts are needed to install?
Basically you are simply swapping out the old regulators with the powered units and wiring up the harness. In theory you don't need anything more.... in reality when something comes apart you can usually count on "Unforeseen Conditions" that will need attention. I ended up replacing the felt in the window channels and needed to source the large star locking washers to secure the regulators once they were in place and adjusted..... I had to buy 100 of them so if anyone needs some let me know.... Haha!
By lengthening the regulator adjustment slots you'll gain a bit more adjust-ability during the installation and save a bit of time....