The other issue you should be aware of is that the lower quarter panel at the wheel wheel opening is shorter from the lower pinch weld than it is at the front joint. To fix this issue you can either cut a long slit in it and weld that closed to change this or you can re-bend the 90 degree bend for the pinch weld seam.
Oh crap. I think I screwed that up. I do recall pulling whats left of the fender lip outward to make it line up. Maybe I can bend the rear of the inner rocker inward to fix it? How far in should it go? As of now the outer rocker is still not welded to the inner rocker at the bottom. My original inner rocker hung down a varying 1/16" further than the outer rocker and fender so just for the heck of it I left that little offset show like new. Don't know if they were all that way.