Chevy Tri Five Forum banner
advice
1-6 of 6 Results
  1. Transmission and DriveLine Questions
    I have a 57 Chev Belair. I am trying to change the stock 57 rear end to a 1970 firebird rear end. But the u joints are different sizes. How can I make this work?
  2. Non Trifive Vehicles
    Hey folks, I have a restomod 1959 Chevy Impala that I acquired from Belton, Missouri in July. Everything is going as planned but I like to stay ahead of the momentum. I have been looking into tires and wheels and too much unfamiliar information has presented itself. What I have in mind is 15"...
  3. Chit Chat Area, Anything on your mind goes here.
    We are looking to buy at least one of two cars avalaible. The first is a red 1957 150 with a straight six, that matches the body, with 103k original miles. The interior is original and in good shape, and the paint, while non orginal, is also in good shape. This is the car we are primarily...
  4. Fuel Systems/Injection, Carburation, Supercharging
    I just had my carburetor gaskets replaced and all that, and i found that the carb is shot. It wont keep the idle that it is given so it is stuck on high idle. So what would you guys recommend for a four barrel carb? I have a 57 intake manifold on there according to the numbers (3731398) and I...
  5. Welder advice, Hand tool Advice Shop Tool.
    So I'm close to starting my 1955 Chevy Bel Air project. I'm doing this one on my own and would like some advice! What type of welder do you guys use for welding body panels on your projects? I.E. Rocker panels, floor panels etc etc? I have some welding experience, I am no expert, just a hobbiest...
  6. Welder advice, Hand tool Advice Shop Tool.
    Getting ready to drag my 57 2 dr hardtop home and trying to get my home shop well equipt. Car has been in storage for over 10 years and not been touched. this will be my first build. I'd like to get a welder, not only for the chevy build, but also for other odds and ends - and quite frankly...
1-6 of 6 Results
Top