Chevy Tri Five Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-3 of 3 Results
  1. Transmission and DriveLine Questions
    I'm going to have my rear axle rebuilt and install new 373 gears and Timken bearings. Id like to ask experienced folks who have the same exact rear that I do (Stock 1957 Bel Air rear end) what the best practice is. And are the copper washers on the bolts necessary?
  2. Stock Chevy Discussion 55-56-57
    So its 1,2000 miles now since my engine rebuild, and in the past 200 miles my engine burned a quart of oil. The 500 miles before that saw 2 quarts burned. Ibe been varying the RPMS like mad but it just keeps goin My engine has been runnin pretty hot too, today i left it for a little bit and it...
  3. Hi Performance
    Installed 468 rebuilt with all the best. Large oval port heads, dual edelbrock thunder series 500 carbs. Mother thumper cam all roller. I have about 2 hours on the motor. Followed break in procedures. Set timing and adjusted air fuel mixture at carbs. At first time getting to operating...
1-3 of 3 Results