Chevy Tri Five Forum banner

clips

  1. Suspension Questions Chassis, Brakes, Shocks, Etc
    New to this and am starting on a 57 short box. Just bought it and prior owner put in a big block and a 71 Camaro rear end. I plan to drive it on an almost daily basis other than winter. Want to do power steering and must upgrade the brakes - too much HP not to. The front chassis is original...
  2. Paint & Bodywork Questions and Answers
    Guys- I bought a complete set of molding clips for a 57 210/BelAir. The photo is of three types of clips in the bag for the upper quarter and door. These are for the trim that runs along the bottom of the quarter window and along the bottom of the door window (am I right?). I know where the...
  3. Chit Chat Area, Anything on your mind goes here.
    I am looking for the clips that help hold the rear 1/4 window garnish molding against the glass. It looks like there are mounting holes for the window roller and for two clips on each side. I have one clip. It is U shaped with short legs that go through two holes in the interior metal at the...
  4. Stock Chevy Discussion 55-56-57
    Ok I have read countless threads about how much of a pain it is to install the rear trim. The consensus says the following: Rubber: Danchuck is to thick and doesnt fit well Softseal is good (This is what I have and still having trouble) T&N is suppose to be the one to use but very hard to...
  5. Interiors Questions and Answers
    I need help installing my U Channel Felt on my '57 210 4DR Sedan. I got my Re-Pops U Channels from H & H and I'm trying to install them with the Clips I got from Eckler's. The clips are supposed to punch through the channel and then I'm supposed to bend over the tabs on the inside of the...
Top