Chevy Tri Five Forum banner
conversion
1-10 of 10 Results
  1. Suspension Questions Chassis, Brakes, Shocks, Etc
    I am changing mt 56 over to power disc brakes and everything has worked out well until I got to the booster mounting, my car is a factory Power Steering car and the booster and Master cylinder come straight out and hit the P.S. res. I am trying to find a brake that will offset my booster enough...
  2. Transmission and DriveLine Questions
    Hi guys, A little back story: as much as I love everything stock and correct on Miss Pearl my Dusk Pearl 57 Chevy 2dr HT, I had the original cast iron Powerglide rebuilt 5 years ago, just week after restoration getting the car on the road and inspected it slipped and apparently blew up inside...
  3. Stock Chevy Discussion 55-56-57
    A few questions does anyone know the right Master and brake booster for 1957 Chevorlet Belair that will fit with stock power steering pump and generator? This is my set up i had a hydrovac on fender with single stock Master! well it worked great but it's shot and i wanna go with stock brakes and...
  4. Stock Chevy Discussion 55-56-57
    I put a Th350 behind a stock 57 Belair 283 and i'm not able to put the emergency brake bar across brackets because tranny is too low but with the driveshaft in it looks like a straight shot to rear end? Here is my set up if anyone can help? 283 basically stock except cam and intake, swapped...
  5. Transmission and DriveLine Questions
    *57 Chevorlet cast iron Powerglide 2 speed/th350 conversion 1957 Chevorlet belair 210 center post 283 engine iron Powerglide two speed/ th350 conversion, I used stock front motor mounts with new bushings, center bell housing conversion mounts and rear cross member conversion! Is 3 points...
  6. Transmission and DriveLine Questions
    Hey Everyone, I just converted my 57 4-door from a 235 with 3 speed to a 350 with a th-350 trans. Is there a conversion for the speedometer cable? Does anyone know what would work for this change over? Any help is greatly appreciated.
  7. Suspension Questions Chassis, Brakes, Shocks, Etc
    Hi I am looking to switch from drum to power disc brakes on my 1957 bel air there are so many kits out there and want something that I don't have to do much modification and I need a point in the right direction. I have a big block motor so I need decent braking but don't want to go 4 piston...
  8. Suspension Questions Chassis, Brakes, Shocks, Etc
    I saw this Coil Over Conversion Kit in the Eckler's catalog (part #21-501) and would like to know if anyone has installed it and what they thought about it. My car already has the springs moved in and has been mini tubbed with a 9" rear end. Here is a link to the item and there is a installation...
  9. Suspension Questions Chassis, Brakes, Shocks, Etc
    I am looking at purchasing a front disc conversion kit and was wondering if there was anything out there that people might recommend or not recommend, looking for an easy install, appearance doesn't matter as my rims will cover and off-set can't change to drastically... Thanks
  10. Electrical Questions and Answers
    Hi I have a 1957 Chevy 2 door Bel Air Sedan and I recently bought the Raingear electric windshield wiper changeover kit and I found out that I am missing the brackets that it needs to mount to under the dash, they must have rusted off because my original wipers have never worked. It looks like...
1-10 of 10 Results
Top