Chevy Tri Five Forum banner
ls1
1-19 of 23 Results
  1. Electrical Questions and Answers
    I am trying to troubleshoot an LS1 MAF/IAT sensor problem that might be causing the engine to not idle. It will start and run if I keep my foot on the throttle - but does NOT idle without dying. When I check the sensor reference signal, I measure 6.9 volts where it should be the normal 5 volts...
  2. Tri Five Cars for Sale
    1955 Chevrolet Bel Air Convertible in Red & Black over Custom Red Leather Interior. Equipped with a Supercharged LS1 Engine mated to a 4L60E Automatic Transmission. This beautiful Bel Air is an incredible no expense spared rotisserie restoration. Completely updated with modern components and...
  3. Electrical Questions and Answers
    I pulled an LS1 and 4L60E from a 1990 Chevy Caprice to put in my 57 Chevy Bel Air. Everything was going fine right up to the point where I got to the wire harness. Has anyone ever done this? What did you do with the wiring?
  4. LS & LT Installation Questions and Answers
    Hi all, Still building my 57 HT with LS1, about 5 years now?? I have a question which should be simple. I mounted the coil packs on top of the valve covers, everything ok. The problem is that the right coil, toward the rear, is very very close to the fire wall. It almost touches the air box. I...
  5. LS & LT Installation Questions and Answers
    Hi all, been a while since I posted on the site. The trifive nationals were great, can't wait till this year. I finally finished the body on my 57ht and am ready to sit it back on the frame. I installed a LS1 and a tremec 6 speed out of a 2000 camaro. I have the complete donor car. The engine is...
  6. LS & LT Installation Questions and Answers
    I'm going to try to consolidate this into one thread if possible. I'm doing a 57 w/04 GTO LS1, (4L60E, if it matters). The engine has a 4" intake. I went out and bought Spectre 4" components and hobbled together a respectable Cold Air Intake. I went and bought my stock 04 GTO MAFS only to find...
  7. Super Stock/Pro Street & Modified Disc. 55-56-57
    Hello,new to the forum and pretty new to trifives.Ive done a lot of Camaros chevyII"s and chevelles but not much experience with 55's.I like and appreciate originals but have come to love ls1's,they are hard to beat in a car you want to drive a lot.I recently accquired an all original and rust...
  8. Super Stock/Pro Street & Modified Disc. 55-56-57
    I have an LS1 Engine in my 55 and it has 530hp. I am in the middle of cutting out the rear end and installing a 9" Moser rear-end, tubing it to install 12" wheels. My question is this, at this point I am being recommended to install a roll bar. I particularly do not care to install one, (don't...
  9. LS & LT Installation Questions and Answers
    I am using a 2002 Camaro LS1 engine in my 57. I have a new Stewart Warner speedometer that interprets any signal from 3,000 to 100,000 pulses. I cannot get it to operate or calibrate properly. I am wondering if the signal coming from the PCM is stepped down to 5 volts. (Pin 50, red connector...
  10. 100_0630

    57 Chevy, Chopped, 59 Chevy roof, LS1, Air bags,
  11. 100_0626

    57 Chevy, Chopped, 59 Chevy roof, LS1, Air bags,
  12. 100_0619

    57 Chevy, Chopped, 59 Chevy roof, LS1, Air bags,
  13. 100_0612

    57 Chevy, Chopped, 59 Chevy roof, LS1, Air bags,
  14. 100_0605

    57 Chevy, Chopped, 59 Chevy roof, LS1, Air bags,
  15. LS & LT Installation Questions and Answers
    I swapped an LS1 engine and an 81 Camaro front subframe into my 57 and I have power steering. The LS power steering pump was designed to feed a power rack and pinion. The Camaro subframe uses a Saginaw steering gear box. Does anyone know if the pump will deliver enough (or too much) volume and...
  16. 57 Build

    Satin black
  17. 57 Build

    Smoothed hood skin
  18. 57 Build

    Slammed Sedan, LS1, Camaro subframe
  19. 57 Build

    Chopped 1 1/2". 59 Chevy roof.
1-19 of 23 Results
Top