Chevy Tri Five Forum banner
posi
1-7 of 7 Results
  1. Transmission and DriveLine Questions
    I’m in the midst of building my 57 Delray and have a couple options. It currently has a mild 350 with TH350 with stock 3.55 open rear (haven’t driven it yet). I have all the stuff to convert it to 700R4 except shortening the drive shaft. I have a 3.08 posi with P case built for the TH350 but...
  2. Transmission and DriveLine Questions
    So I finally got my 56 running well enough to try some power braking to try and smoke the tires. What I discovered was my car is Putting down TWO two marks on the street, and from all the great info on TriFive.com has lead me to believe it is a stock 1956 Chevy rear end with 3:73 gears. I'm...
  3. Transmission and DriveLine Questions
    I have a 62-64 Series 4 4:56 posi rear that I bought with a chipped ring gear. The unit was disassembled and my question is what is the sequence for the installation of the plates? Left and right side plates were kept separated. I'm just not sure of the order of the beveled and flat plate...
  4. Classifieds Section - For Sale Items ONLY!
    1962 "P" CASE WITH 4.56 GEARS. PART # 3788812 DATED L91 THIS HAS BEEN IN STORAGE FOR YEARS AND WAS A WORKING UNIT. BUT SHOULD BE TAKEN APART FOR CLEANING ETC. IT DOES ROTATE FINE, GEARS LOOK GOOD. CENTER SECTION CAST # 3789812, POSI IS THREE SERIES C-30743 STAMPED RATIO CODE AND DATE ARE CB...
  5. Classifieds Section - For Sale Items ONLY!
    1962 "P" CASE WITH 4.56 GEARS. PART # 3788812 DATED L91 THIS HAS BEEN IN STORAGE FOR YEARS AND WAS A WORKING UNIT. BUT SHOULD BE TAKEN APART FOR CLEANING ETC. IT DOES ROTATE FINE, GEARS LOOK GOOD. CARRIER IS NOT BEAT UP. $750 SHIPPED First I will take it. Money order or PayPal Lower 48 only
  6. Transmission and DriveLine Questions
    Hello fellow Tri Fivers! I am putting a posi rear end together for my 57 and cannot seem to get the drivers side axle to seat all the way. I have aligned the inner/outer splines but the axle is 3/8" from being "in" - it stops about where the O ring channel on the bearing is- It's a 57...
  7. Classifieds Section - For Sale Items ONLY!
    I have a complete rear end that was just pulled from our car. It is complete from drum to drum. Includes rear end housing, 5.13 posi rear differential, axles, brakes, drums, emergency brake, and leaf springs. Rear differential stamping is 3743833 w/ L 9 7 (Dec 9, 1957 manufacture) the...
1-7 of 7 Results
Top