Chevy Tri Five Forum banner
sway bar
1-6 of 6 Results
  1. Suspension Questions Chassis, Brakes, Shocks, Etc
    Y'all, I recently installed a set of Hotchkis sway bars, which went in easily and fit well with the exception of the rear bar's endlinks. They measure 8" center-to-center, which put the bar ends at a 40° angle from level. The links needed to be ~4.5", so I fabricated a set from QA1 rod ends...
  2. Suspension Questions Chassis, Brakes, Shocks, Etc
    I was mocking up my CPP Front Sway Bar tonight on my 57 with my new CPP tubular control arms so I could mark where the holes needed for the brackets. The car was sitting on the floor and not on jack stands. The question I have is whether anyone has dealt with the sway bar sitting on the...
  3. Suspension Questions Chassis, Brakes, Shocks, Etc
    I want to fit a sway bar to my 1957 chevy 210 station wagon It has disk brakes fitted with 15"wheels and a replacement short block 350 engine approx 1973. Can you recommend which one I can use with a minimum of drilling etc. Thank You :p3:
  4. Suspension Questions Chassis, Brakes, Shocks, Etc
    I have installed a 1981 Camaro front sub frame in my 57 Chevy. I narrowed the crossmember 2". I am almost finished with the car now and I would really like a sway bar for the front. In order to use the original Camaro bar I would have to cut 2" out and weld it back together like I did with the...
  5. Suspension Questions Chassis, Brakes, Shocks, Etc
    First post... Looking to put front disk brakes (manual) on my 57 Bel Air 2dr ht. I've got the 7/8" sway bars front & back from Ecklers installed. I've been looking at mgchevyparts brake kit, http://www.ebay.com/itm/190607644483?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649 In the sales...
  6. Suspension Questions Chassis, Brakes, Shocks, Etc
    All, I need some photos or help. I have rebuilt the front end with the tubular lower and upper a arms (57 2dr hardtop) and I went to install my swaybar and realized that the "L" bracket that normally is used to install the ends of the sway bar to the arms wont work on the tubular arms. Anyone...
1-6 of 6 Results
Top