Chevy Tri Five Forum banner
1 - 2 of 2 Posts

· Trifive Automotive Electrical Wiring Expert
26,974 Posts
Have new gas sending unit that reads 7/38 instead of 0/30. Can I adjust by bending tabs or rod at tabs?
Is this inside or outside the tank? Is your ohmmeter reading correctly? Weak batteries will make an ohmmeter read wrong.
If it's still outside the tank, connect the sender wire to it and ground the mounting plate to the body and move the arm from empty to full while someone watches the gauge. I don't think you can bend the float arm stops that much.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.