[55 Rescue Dog]

I am in the process of installing new door windows and all of the seals and fuzzies. I'm looking for a clean cut to trim the end of the window fuzzy surround where it contacts the vent fuzzy on a 2dr sedan. I used my chop saw on the vertical steel vent channel which wasn't a great idea. The fuzzy that surrounds the window is fairly soft and side cutters or scissors might work but looking for other ideas. Thanks

 

[Pops @ Tri-5.com]

Dremel tool with cut-off disc works well

 

[jab64]

to cut the channel guide I used an air tool with a cutting wheel. Worked pretty good. For the fuzzies on the door and garnish moldings I used a sharp steel chisel and hammer and shear it on the flat of my vise. All I've ever done to any car and I have to say that is the worst job I've EVER done. Sympathies my tri-5 friend Patients and all will work out fine I'm sure. Good luck !