Chevy Tri Five Forum banner
Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 · (Edited)
I have a complete 4 speed set up for sale I just removed from my 1956 210 Sedan. I'm running a big block with long tube headers. The trans wouldn't shift right in 1st & 2nd so I pulled it & went with a TH400 that I had. I ran this set up for just over a thousand miles. We tore trans down & found some bad parts & replaced them, along with all new gaskets, seals, etc. costing over $400 in parts alone. I would like to sell complete setup, it would be perfect for someone doing a build & wanting a 4 speed, here is what's included:

Richmond super T10 transmission with shifter & all linkage, shifter is powder coated aluminum color & shaped for a bench seat.
Centerforce clutch discs & pressure plate
GM flywheel & dust cover
GM truck bellhousing, modified for long tube headers & machined for throw out bearing travel to be correct
McCleod hydraulic throw out bearing
Wildwood master cylinder with braided stainless lines

Located in Tuscaloosa, Al
 

·
Registered
Joined
·
14 Posts
Discussion Starter · #2 · (Edited)
I have a complete 4 speed set up for sale I just removed from my 1956 210 Sedan. I'm running a big block with long tube headers. The trans wouldn't shift right in 1st & 2nd so I pulled it & went with a TH400 that I had. I ran this set up for just over a thousand miles. We tore trans down & found some bad parts & replaced them, along with all new gaskets, seals, etc. costing over $400 in parts alone. I would like to sell complete setup, it would be perfect for someone doing a build & wanting a 4 speed, here is what's included:

Richmond super T10 transmission with shifter & all linkage, shifter is powder coated aluminum color & shaped for a bench seat.
Centerforce clutch discs & pressure plate
GM flywheel & dust cover
GM truck bellhousing, modified for long tube headers & machined for throw out bearing travel to be correct
McCleod hydraulic throw out bearing
Wildwood master cylinder with braided stainless lines
Please contact me for pricing, I think this set up is over $4000 if purchased new. Yes, I know mine is used
 

·
Administrator & Tech Articles
Joined
·
51,898 Posts
1 - 7 of 7 Posts
Status
Not open for further replies.
Top