[Darrin's55]

Will this epoxy primer be some what like the factory epc coating that comes on the Taiwan replacement panels.

I need to prime the inside of my new quarter panels there bare metal.

If not what ppg do i need?


thanks Darrin

 

[1320/150]

its actually way better. That epoxy primer would be perfect!!

 

[roger1]

I've never used DPLF. But I have used a lot of SPI epoxy primer. It's all I've ever used since I switched to using epoxy about 5 or 6 years ago.
You might want to try it. It's a lot cheaper and has free shipping if there is no jobber in your area.
I've read a lot of reports over on hotrodders.com where people that have used both and like the SPI better. I never heard a report where someone used both and liked the DPLF better.

 

[Rick_L]

DPLF is a good product, you won't go wrong. The 90 is the flat black color, I think there's about 5 others.

 

[chevrolet150]

Dp90LF is all I use over bare metal.

 

[porchdog]

you can save a lot of money and end up with more material by using spi epoxy. it is a 1:1 mix instead of 2:1 . it is also much cheaper . it is suitable for a med build surfacer and sands quite well.

2 gals sprayable for the price of 1 gal dplf without acc / reducer.

 

[roger1]

The SPI is $74.60 per sprayable gallon (unreduced) .
I just ran a figure using TCP Global prices for DPLF and came out to a price of $169.80 per sprayable gallon (unreduced) figuring the 2 to 1 mix and accounting for the quart price of activator.

 

[Darrin's55]

I picked up some dp90 today. Hope to get it sprayed this week on the inside of the panels so I can install them.


Thanks guys