Chevy Tri Five Forum banner
1 - 4 of 4 Posts

· Registered
Joined
·
60 Posts
Discussion Starter · #1 ·
Hi guys!
I've been welding in some panels on my 55 2DR SDN. I started with the toe boards since this is my first time welding in panels.
I've been reading a lot of threads on doing this work.
I know that patience is a big part of not grinding too far.
My question is what is the proper sander to use for the final dressing. I have a 5 inch high speed sander that workd ok if you have the room. I noticed that Robert (I've read alot of his posts) says he uses a 3 inch angle sander but I can't seem to find the right tool.
Also is there a good supplier for these sanding discs and cut off wheels?

Thanks
Steve
 

· Registered
Joined
·
60 Posts
Discussion Starter · #6 ·
Hey guys thanks for all of the info!
I'll pick up those tools and discs. I knew that there was something else/better than what I've been using but I couldn't seem to find anything.
My hope is by the time I'm finished with the floors and or areas that can't be seen I'll be doing good enough for the lower quarter panels.

I'll post some progress soon.

Steve
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top