Chevy Tri Five Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
492 Posts
Discussion Starter · #1 ·
Has anyone ever used HTS-2000 aluminum repair?

I pulled my 350 out of the 57 and it was smooth and easy...of course, stupid didn't use a cradle jack to support the new TCI TH400 and it slipped off conventional jack and broke an ear (dust shield bolt hole). At least it wasn't a critical area but I was still sick to my stomach. Started googling aluminum repair and ran across this HTS 2000 stuff on youtube. It looks pretty good.

Whacha think?:eek:
 

·
Registered
Joined
·
492 Posts
Discussion Starter · #6 ·
jb weld

if its not a load bearing and is just used to hold a dust cover I would deffinitly save the expense and break out the jb weld and call it a day.

OK. Slopped on the jb weld and it seems to be working. I really have an urge to use a rubber mallet and give it a couple love taps just to test [email protected]#@!#@%^T%*$

I hope it holds
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top