Chevy Tri Five Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
128 Posts
Discussion Starter · #1 ·
Hello All:


I am in the process of building my own 2" lowering blocks and I need to know what size of hole should be in one side and the size of the locating pin on the other side.

Stock rear end in a 55 Sport Coupe


Thanks in advance, :hmmmm2::hmmmm2:
 

·
Registered
Joined
·
136 Posts
do like i did... take the center bolt out of the spring drill thru the block and bolt the block and spring together..... you need to buy grade 8 bolts 2 inches longer than the orig center bolt....this way nothing moves.... i made my blocks out of 2x4 solid steel after blowing the aluminum blocks apart:anim_25:
 
1 - 5 of 5 Posts
Top