Foamless Sturdy Paint/Liquid Mixer - Mezclador de Pintura/Líquidos Robusto sin Espuma by AlmeidaJuan
Basic foamless mixer/stirrer for paint and other moderate viscosity fluids. It goes with a 8mm wood shaft (doesn't need to be exact) Prints in 1 hour depending on your settings and it need support for the shaft coupling. 60mm maximum diameter. Very simple and efficient. Mezclador básico sin...
www.thingiverse.com
Paint Mixer 3/8 Dowel by peteeisen21
Power drill paint mixer. Using 3/8 or 10mm dowel. Use epoxy to bond the dowel to the mixer.
www.thingiverse.com
Paint mixer by Metaldrgn
Simple paint mixer. Structurally reenforced. One way to use it that I found works best is to find a threaded rod from a hardware store that is roughly the same max diameter as the hex hole. Heat it up with a torch (doesn't need to be red hot, enough so it can melt the material and stay hot...
www.thingiverse.com
Paint Mixer by Maxhorizon
Jason has a great design, I modified it to use a 3/8" threaded rod to beef it up.
www.thingiverse.com
Cordless drill boat propeller by jerid
160mm Diameter 5/16 hole Power your small boat with a hand drill. Works good.
www.thingiverse.com
Paint mixer / stirrer by Splicing
Paint mixer / stirrer for small paint cans e.g 500ml or 1L. However, it could be scaled to suit other paint can sizes. The design was kept simple to allow easier cleaning. The diameter of the outer ring is 50mm and shaft size required 6mm.
www.thingiverse.com
