Chevy Tri Five Forum banner
1 - 1 of 2 Posts

· Registered
1,159 Posts
Discussion Starter · #1 ·
Does anyone out there make a polyurethane or polygraphite rear motor (trans) mount to replace the stock rubber mounts? My right side mount is totally separated, and the left one isn't far behind. Due to the configuration of my exhaust, I can't put a trans crossmember in, though that would probably be the best way to go. I'm running a Tremec T3550 trans, and its kinda heavy. I'd hate to have to put another set of rubber mounts back in, knowing they will split again in the future.

1 - 1 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.