Chevy Tri Five Forum banner
Cancel

Replacement Qtr panel?

1195 Views 3 Replies 3 Participants Last post by  auggie56, 
chevjyd
Hey guys, I was wondering how complete is a complete replacement Qtr panel. I have some rot from the corner of the rear window down the side of the Qtr. Its right where the upper suport sits or where mine once sat! It also has the typical lower rot. Wondering if a new one goes to the factory seems or has to be spliced in.
Oh ya its on a 56 2dr Hard Top.
Thanks, Jeff
Reply
Save
Like
1 - 1 of 4 Posts
Booty
Not Sure -

Check the sponsors on here or you can check this store in Orange, Ca. - they have a lot of sheet metal and they're usually cheaper than others: Good Luck!:)
http://www.truckandcarshop.com/4957.html
Reply
Save
Like
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Chevy Tri Five Forum
A forum community dedicated to 1955, 1956, and 1957 Chevy owners and enthusiasts. Come join the discussion about restoration, engine swaps, reviews, performance, modifications, classifieds, troubleshooting, maintenance, and more! Open to all models including Belair, 210, 150, Sedans, and Nomads.
Full Forum Listing
Explore Our Forums
Chit Chat Area, Anything on your mind goes here. New Member Introductions Stock Chevy Discussion 55-56-57 Project Update Section, Post Project Updates Here Suspension Questions Chassis, Brakes, Shocks, Etc
Top