Chevy Tri Five Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
839 Posts
Discussion Starter · #1 ·
I have replaced the center section of my trucks dash with a middle
replacement section and have it in completely,But have ground down the welds and accidentally hit the round Knob area with my grinder and now
have to build it up with filler and sand the Radius smooth!
My ? is what do you guys use for the tedious area's around the dash to get the Circles smooth and next to it the flat area's?
appreciate any suggestions! i have it about 95% Complete but it needs
a little more attention to get them straight!

Thanks Allen
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top