Chevy Tri Five Forum banner
Cancel

TCI lockup question

645 Views 2 Replies 2 Participants Last post by  56flamejob, 
56flamejob
Hey everyone, im in the middle of my 200r4 swap and i have a couple questions about the lockup kit i installed

http://www.summitracing.com/parts/TCI-376600/?rtype=1

1: the 2 wires that attach to the fourth gear pressure switch are not labeled +/-, does it matter how i hook them up?

2: there was a part that i believe isnt to be used again, small and silver, looks like the fourth gear pressure switch but has 2 prongs coming from the side. that is no longer used right?

last 1: same as the 1st but pertains to the black vacuum switch that gets mounted on the outside, +/- isnt labeled, does it matter?

thanks a lot everyone
Reply
Save
Like
1 - 1 of 3 Posts
R
1. It doesn't matter which terminal you connect each wire to.
2. Probably not.
3. Same as #1.

I don't know what the instructions look like, you need to be sure the pressure switch they supplied is in the correct port. Since you didn't ask, I assume that's clear in the instructions.
Reply
Save
Like
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Chevy Tri Five Forum
A forum community dedicated to 1955, 1956, and 1957 Chevy owners and enthusiasts. Come join the discussion about restoration, engine swaps, reviews, performance, modifications, classifieds, troubleshooting, maintenance, and more! Open to all models including Belair, 210, 150, Sedans, and Nomads.
Full Forum Listing
Explore Our Forums
Chit Chat Area, Anything on your mind goes here. New Member Introductions Stock Chevy Discussion 55-56-57 Project Update Section, Post Project Updates Here Suspension Questions Chassis, Brakes, Shocks, Etc
Top