Chevy Tri Five Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
68 Posts
Discussion Starter · #1 ·
I am in the process of moving my alternator to the driver side over the ps pump to get ready for air. Only problem is that it sets on the valve cover. They are center bolt and 3 7/8 inch high. The motor is a vortec and has roller rocker arms and they are 3 inches high. I have looked at several covers at summitt and jeggs, but they do not show height, they only say tall.

What I think I need in one around 3 1/4 to 3 1/2 with the ends that are rounded. Suggestions.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top