Wiring placement License plate frame.

sam1el · Apr 28, 2010

SO i found out I have 1 piece bumpers after having to cut my bumper guards off......

Apparently the previous owner had gotten rear ended and they were loose so he tightened the nuts on and welded them solid. So after having to cut them to remove them I decided I really like the smoothie bumper looks.

So rather than spending the 170 on new guards I purchased the license plate frame with light built in from Danchuk. I plan to put it in the same spot as the original plate frame but want to make sure I can hide the wires from plain sight as best as possible. Anyone have any suggestions?

chevman57 · Apr 28, 2010

Sounds like the way i plan to wire my 3rd brake light, when i get one. I would run it with the hinge and then into the inner structure of the trunk lid to the license frame.
Terry

sam1el · Apr 28, 2010

chevman57 said:
Sounds like the way i plan to wire my 3rd brake light, when i get one. I would run it with the hinge and then into the inner structure of the trunk lid to the license frame.
Terry

Sounds like a plan actually close to what I was thinking. I'm just a little weary of having to drill a hole in my trunk lid

BTW, they also had this frame with a 3rd brake light option built into it. Was a little more expensive but not too bad.

Will · Apr 28, 2010

Just a thought on a 55/56 have one of the bracket bolts drilled through the center and run the wire thru in to the trunk. On a 57 drill a hole through the rubber bumper. I have a 55 trunk lid on the 57 with the 55/56 bracket. That's what I plan to do.

sam1el · Apr 29, 2010

That is essentially what I did. It looks pretty good.

Wiring placement License plate frame.

sam1el

chevman57

sam1el

Will

sam1el

Top Contributors this Month

Recommended Communities