Does anyone have to change this and were to get them from, i have search on the internet but not find.
They have strange mesures and are like this:
Base opening DIA: 56,5mm about 2,224 inch

Pin Opening DIA: 16mm about 0,629 inch

Heigth of boot: 30mm about 0,629 inch.
So please advise me

 

I think these are the ones I got with my MII upper & lower tubular A-arms

Replacement Screw-In Ball Joint Dust Boot, K772 Application

These replacement dust boots are for screw-in type ball joints, like the ones featured in our Mustang II tubular control arms. They work with K772 type ball joints. Replacement for K772 type ball joints Fits upper or lower Metal support ring integrated into base of boot Sold each

www.speedwaymotors.com

 

This happens way too often lately, It is the Chinese trash rubber.

 

Hi
Yes i know but i also thought that and order them, but they will not fit to tall and base is to wide. So i dont what to do right know

 

Did you look here? Dust boots by size. Universal Tie Rod and Ball Joint Boots

 

When I installed my Mustang IFS they mentioned something about Extensions that you could get if needed. Are the boots too short or is your rack maybe too narrow , causing undue stretching of the boot? Just thinking out loud. Good luck!