I am going to install an MSD ready to run distributor with MSD 8.5mm wires. I am running a 327 with rams horn manifolds in a 55 vert. The wires will run under the manifolds but on the right side at the rear the wires are really close to the manifold and there is little space due to the firewall. What do you guys use to shield the wires in this area?
BeachVette6
55 HT, ZZ4 w AFR's, 700R, 3.55 Posi
Joined
·
62,265 Posts
BV6.....This illustration shows the spark plug wire routing on an original 57 V8 with rams horn manifolds:http://www.trifive.com/garage/57 Chevy Assembly Manual/221-15.gif
Often wondered if the Corvette heat shields could be used
![Image]()
Often wondered if the Corvette heat shields could be used
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
